Using Standby Mode; From The Main Window; From Any Navigon 8100T Window; Switching The Device Back On From Standby - Navigon GPS Navigation Receiver 8100T User Manual

Using Standby Mode

Note: Use Standby mode only when your device will be unused for a very short time. If
left in Standby mode for an extended period, battery drain can occur as the GPS
receiver continues to draw power. For longer periods of inactivity, see "Turning off the
NAVIGON 8100T" on page 18.
Note: To further conserve battery power, the device resets itself if left in Standby
mode for a longer time.
Standby mode conserves battery power. When the device is switched back on from
Standby, the window that displayed when the device was set to Standby re-displays.
There are two ways to switch your device to Standby.

From the Main Window

On the M
AIN
• Tap the

From Any NAVIGON 8100T Window

• Press and hold the
release.

Switching the Device Back On From Standby

To switch the Device back on:
• Press and hold the
release.
Note: If a password has been created for the device, the
appears when the device is switched back on from Standby. See "Security" on page 31
for more on using passwords.
December 2008
Version 1.1
W :
INDOW
(Standby) button.
(On/Standby/Off) button for two (2) seconds, then
(On/Standby/Off) button for two (2) seconds, then
NAVIGON 8100T User's Guide
NAVIGON, INC.
Basic Operations
Starting the NAVIGON 8100T
E P
NTER ASSWORD WINDOW
21