Using Standby Mode
Note: Use Standby mode only when your device will be unused for a very short time. If
left in Standby mode for an extended period, battery drain can occur as the GPS
receiver continues to draw power. For longer periods of inactivity, see "Turning off the
8100T" on page 18.
Note: To further conserve battery power, the device resets itself if left in Standby mode
for a longer time.
Standby mode conserves battery power. When the device is switched back on from
Standby, the window that displayed when the device was set to Standby re-displays.
There are two ways to switch your device to Standby.
From the Main Window
On the M
AIN
• Tap the
From Any NAVIGON 8100T Window
• Press and hold the
release.
Switching the Device Back On From Standby
To switch the Device back on:
• Press and hold the
release.
Note: If a password has been created for the device, the
appears when the device is switched back on from Standby. See "Security" on page 31
for more on using passwords.
November 2008
W
:
INDOW
(Standby) button.
(On/Standby/Off) button for two (2) seconds, then
(On/Standby/Off) button for two (2) seconds, then
NAVIGON 8100T User's Guide
NAVIGON, INC.
Basic Operations
Starting the NAVIGON 8100T
E
P
NTER
ASSWORD WINDOW
21