Table 5-1. Calibration Component Identification - National Instruments SC-2040 User Manual

Eight-channel simultaneous sample-and-hold accessory

Hide thumbs

Table Of Contents

Table of Contents

Chapter 5

Your accuracy needs determine how carefully the offsets need to be calibrated. A typical

requirement might be for total offset referred to output to be less than half of an LSB of the DAQ

board being used. For example, a 12-bit, 20 V system has a resolution of 20 V/2

Calibration to under 2 mV would thus be sufficient for most applications. The SC-2040 is

factory calibrated to have total offset referred to output of less than 2 mV at low gains.

Table 5-1 shows which pots to adjust for each type of offset for each channel and which DIP

switch selects the gain for each channel. Refer to the parts locator diagram in Chapter 2,

Configuration and Installation, to determine the location of each component.

Channel

Output Offset Adjust

A complicating factor in the calibration of the board is that the output offset is not the same in

track mode as in hold mode. This difference is because of a phenomenon known as hold step, in

which a small amount of charge is transferred to the track-and-hold amplifier hold capacitor

during the transition from track mode to hold mode. This charge transfer slightly changes the

voltage at the output of the track-and-hold amplifier.

The magnitude of the hold step on the SC-2040 is approximately 5 mV, enough to make it

necessary to calibrate output offset in hold mode rather than track mode. You may calibrate

input offset without switching the board to hold mode.

To calibrate the SC-2040 board, the following steps are required:

1. If you are using a rack-mount kit, remove the cover to expose the DIO switches and jumpers.

Connect the board so that the pots and DIP switches are readily accessible.

2. Short each input of the board to ground.

At low gains, more alternatives exist to serve as a short circuit, but at a gain of 500, 1 mV

referred to the output is only 2 V referred to the input. Thermoelectric effects make it

difficult to keep a short circuit from generating such voltages. The best solution is to use

short lengths of heavy copper wire, and to keep the short away from heat sources.

3. Program the DAQ board to take data in the differential input mode.

The SC-2040 should switch between track mode and hold mode, with the DAQ board

sampling occurring while the board is in hold mode.