Eptz3600/3600I Function Setup And Operation; Manual Control Mode; Auto Tracking Mode (For Auto Tracking Models Only); Auto Pan Mode - EverFocus EPTZ3600 User Manual

4. EPTZ3600/3600I FUNCTION SETUP AND OPERATION

4.1. Manual Control Mode


Manual control: Shift Joystick Up/Down/Left/Right, and turn it
Clockwise/Counterclockwise to control speed dome.
Use the control keys which are Zoom, Focus and IRIS function keys on the
keyboard to Zoom In/Out, focus N (near)/F (Far), or IRIS +/-.
Note: Zoom In/Out control keys will be disabled when entering to OSD menu
mode.

HOME Mode: The camera view will go back to the home position when there is no
keyboard operation in a specific time. The home position and the specific time can
be set by pressing Set + Home.
If you set the time to 0 minute, then the camera will go back to home if there is no
keyboard operation in 5 seconds. This is the minimum no action time for HOME
mode.
Note: If "HOME" function is enabled, dome will go to home immediately after
powering on.

4.2. Auto Tracking Mode (For Auto Tracking Models Only)

 User can control "auto tracking" on or off by pressing "81" and Enter key.
 User can set "manual select object" on by pressing "82" and Enter key.
 Camera can directly go to tracking start point by pressing "83" and Enter key.

4.3. Auto Pan Mode


Two point auto pan: Press A.Pan to enter the auto pan mode, and then the system
will ask you to enter the auto pan speed (1~239). Press Enter to start auto pan.
In order to set the two points, press Set + A.Pan, and then enter the dwell time
(1~127 seconds) of each point. EPTZ3600 begins to pan from point A to point B
74