Cable Needed; Initial Setup - EverFocus EPTZ3600 User Manual

Eptz36x series

Hide thumbs Also See for EPTZ3600:

Table of Contents

2.2. Connections

Power Cable

An adapter with 24VAC/3.5A output provides the power to the EPTZ3600/EPTZ3600I. An

extension power line may be needed.

Note: Different regions may use different ranges for AC voltage. Be sure to check the

voltage range in your area before installing.

Video Cable

A BNC cable is used for connecting an EPTZ3600/EPTZ3600I to a DVR or a monitor. An

amplifier may be needed depending on the distance.

RS485 Cable

The yellow wire carries RS485+, and the orange wire carries RS485-. Connect these

wires to the EKB500 or other control device in order to control the PTZ camera.

Initial setup includes dome address, communication protocol, transmission speed, and

terminal resistance settings. All of the settings should be confirmed before the dome is

powered up. The camera's control settings must match the ones in the control device

Yellow RS485+

Orange RS485-

VIDEO

24VAC

Table of Contents

Eptz3600i