Network Stack Configuration - Asus SABERTOOTH Z170 Manual

The Mass Storage Devices item shows the auto-detected values. If no USB device is
detected, the item shows None.
Legacy USB Support [Enabled]
[Enabled] Your system supports the USB devices in legacy operating systems.
[Disabled] Your USB devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
[Auto] Your system automatically detects the presence of USB devices at startup.
If any USB devices are detected, the legacy USB support is enabled.
XHCI Hand-off [Disabled]
[Enabled] Enables the support for operating systems without an XHCI hand-off
feature.
[Disabled] Disables the XHCI Hand-off support.
USB Keyboard and Mouse Simulator [Enabled]
[Enabled] Enables the support for operating systems without a USB keyboardf and
mouse feature to simulate a USB keyboard and mouse in Windows 7.
[Disabled] Disables the USB Keyboard and Mouse Simulator.
Ensure to install USb driver in your system before you disable this item.
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section 1.2.2 Motherboard layout for the location of the USB ports.
3.6.7

Network Stack Configuration

Network stack [Disable]
This item allows you to disable or enable the UEFI network stack.
Configuration options: [Disable] [Enable]
The following item appears only when you set the Network Stack to [Enabled].
Ipv4/Ipv6 PXE Support [Enabled]
This item allows you to enable or disable the Ipv4/Ipv6 PXE wake event.
Configuration options: [Disabled] [Enabled]
SABERTOOTH Z170 S
3-33