Installation - National Instruments NI PCIe-8255R Quick Start Manual

Installation

To protect yourself and the computer from electrical hazards, the computer must
Caution
remain unplugged until the installation is complete.
Installing a PCIe device into a PCI, PCI-X, AGP, or any non-PCIe slot can
Caution
damage both the computer motherboard and the device. If you are unsure of the difference
between connector types, do not install the device. Refer to the documentation provided by
your computer manufacturer to determine the correct slot in which to install the NI 8255R.
The NI 8255R is intended for a x1 PCIe slot. The NI 8255R will fit into, and can be
Note
used in a x4, x8, or x16 PCIe slot.
© National Instruments Corporation
Remove the device from the package and inspect it for loose components
or any other signs of damage. Notify National Instruments if the device
appears damaged in any way. Do not install a damaged device in the
computer.
Store the NI 8255R in the antistatic package when not in use.
The following instructions are for general installation. Refer to the
documentation provided by your computer manufacturer for specific
instructions and warnings about installing hardware in the computer. Refer
to the Specifications section for a list of the typical power requirements for
the NI 8255R.
1. Install NI Vision Acquisition Software before installing the NI 8255R
device. Refer to the NI Vision Acquisition Software Release Notes for
installation and configuration instructions.
2. Power off and unplug the computer.
3. Remove the computer cover to expose the expansion slots.
4. Choose an unused x1 or larger PCIe slot, and remove the
corresponding expansion slot cover on the back panel of the computer.
Figure 1 shows the different types of expansion slots available on most
computers.
5 NI PCIe-8255R User Manual