Optional Equipment; Safety Information - National Instruments NI PCIe-8255R Quick Start Manual

National instruments interface device quick start guide
Hide thumbs Also See for NI PCIe-8255R:
Table of Contents

Advertisement

Optional Equipment

Safety Information

Caution
The following paragraphs contain important safety information you must follow
when installing and operating the device.
1
When using this accessory with the NI 8255R, three of the digital I/O signals on the device are not accessible. Refer to the
Connectors section of the NI PCIe-8255R User Manual for more information.
NI PCIe-8255R User Manual
National Instruments offers a variety of products for use with the
NI 8255R, including the following:
Digital I/O cable and horizontal DIN rail terminal block
(part number 778790-01)
Digital I/O cable and vertical DIN rail terminal block
(part number 778791-01)
NI Vision I/O Terminal Block and Prototyping Accessory
(part number 779166-01)
24 V, 50 W power supply (part number 778794-01) for powering
isolated outputs
Sony IEEE 1394a high resolution monochrome camera
(part number 778849-01)
Basler IEEE 1394a standard resolution monochrome camera
(part number 778785-01)
LED ringlight and constant current source (part number 778787-01)
12 mm fixed focal length lens (part number 778789-01)
For specific information about these products, refer to the
National Instruments catalog, visit
Instruments office nearest you.
Do not operate the device in a manner not specified in the documentation.
Misuse of the device may result in a hazard and may compromise the safety
protection built into the device. If the device is damaged, turn it off and do
not use it until service-trained personnel can check its safety. If necessary,
return the device to National Instruments for repair.
Keep away from live circuits. Do not remove equipment covers or shields
unless you are trained to do so. If signal wires are connected to the device,
hazardous voltages can exist even when the equipment is turned off. To
avoid a shock hazard, do not perform procedures involving cover or shield
removal unless you are qualified to do so. Disconnect all field power prior
to removing covers or shields.
1
1
1
, or contact the National
ni.com
2
ni.com

Advertisement

Table of Contents
loading

Table of Contents