[Figure 6-35. Motion Setup] - Veilux VR-412D1 Operating Instructions & User Manual

① Select the channel to be set up at {Recording}  {Event}  {Motion Detection} using the arrow
keys and the Select button.
② Select {Partial} on the selection window. The selected channel turns into the 1 channel mode.
③ A green-small rectangle shows at every sells of the image.
④ Move the blue-rectangle to the desired area for Motion Detection and press the Select button.
⑤ Using the arrow keys, designate the motion detection area and the green-rectangle will disappear.
Press the Select button.
⑥ to designate another area, repeat ④-⑤.
⑦ Exit Motion Setup by ESC in the front panel or the right-mouse button.
※ The [Select] button is operated by Toggling.
※ in the above description, the Select button means the button in the front panel
and the same function as double-click of the mouse.
(3) Off
Motion detection in the video is disabled.
(4) Select the motion detection sensitivity
① In the selection window, select the sensitivity using the arrow keys and the Menu button. The
sensitivity can be set among {Lowest} / {Low} / {Meddle} / {High} / {Highest}.
Current sensitivity levels -- Lowest/Low/Middle/High/Highest -- indicate the
proportion of pixels within a block for which motion was detected. Therefore,
the higher the selected level is, the faster the motion that can be detected.
② Sensor (Only VR-412D1 supported)
Veilux VR-412D1 & VR-412C Compact DVR's
www.veilux.net

[Figure 6-35. Motion Setup]

Method of Selecting the Zone
Method of Setting the Sensitivity
51
Operating Instruction & User's Guide