National Instruments Module SCXI-1503 User Manual page 72

Glossary
J
jumper
L
lead resistance
M
m
M
MISO
MOSI
multiplex
multiplexed mode
N
NC
NI-DAQ
NI-DAQmx
SCXI-1503 User Manual
a small rectangular device used to connect two adjacent posts on a circuit
board. Jumpers are used on some SCXI modules and terminal blocks to
either select certain parameters or enable/disable circuit functionality.
the small resistance of a lead wire. The resistance varies with the lead
length and ambient temperature. If the lead wire carries excitation current,
this varying resistance can cause measurement error.
meters
(1) Mega, the standard metric prefix for 1 million or 10
units of measure such as volts and hertz; (2) mega, the prefix for 1,048,576,
20
or 2 , when used with B to quantify data or computer memory
master-in-slave-out signal
master-out-slave-in signal
to route one of many input signals to a single output
an SCXI operating mode in which analog input channels are multiplexed
into one module output so that the cabled E/M Series DAQ device has
access to the multiplexed output of the module as well as the outputs of all
other multiplexed modules in the chassis
not connected (signal)
the driver software needed in order to use National Instruments E/M Series
DAQ devices and SCXI components
The latest NI-DAQ driver with new VIs, functions, and development tools
for controlling measurement devices.
G-4
6
, when used with
ni.com