Units Indication; Run Status Indications; Display Status Of Operation Keypad Of Inverter; Stop Status - Dema Electric D6 Series User Manual

Display
Description
contents
Parameters write is end
Password check error,
Parameters setting error
Ex-work setting values are being recovered

3.1.4 Units indication

Three unit lights could display unit groups as shown in the below chart.
Unit light symbols
A
%
rpm
A+%
%+rpm
A+ rpm
A+%+ rpm
All unit lamp off

3.1.5 Run status indications

The operation panel has three status indication lamps: RUN, REV and EXT, refer to following table for
meanings of indication.
Status indicators
RUN
REV
EXT

3.2 Display status of operation keypad of inverter

3.2.1 Stop status

When inverter is stop, LED flashing display the value of display Parameters (14_00～14_38) that determined
by 0_07 (setting display selection when starting up) .Through ―SHIF T ‖, the Parameters of LED displayed can
turn between parameters determined by 00_07～00_10 ,―RUN ‖ off

3.2.2 Run status

The Inverter enter run status after it receives a right command, LED displays the value of display
parameters(circulation switch between 00_07, 00_08, 00_09 and 00_10 by ―SHIF T ‖) determined by 00_07
(setting display selection when starting up) , ―RUN ‖ on.
Unit Description
A Current unit: Ampere
% Percent
rpm Rotate speed unit: Revolution/minute
s Time unit: Second
Hz Frequency unit: Hertz
V Voltage unit: Volt
kW Power unit: Kilowatt
None No unit or can't display the unit (℃、N、rad /s、......etc)
Status Current status of indication inverter
Off Stop status
On Enter setting instruction
Flashing Accelerating or decelerating state
Off operation direction is forward
On Input reversal instruction
Flashing Reversal accelerating or decelerating state
Off Keypad control status
On Terminal control status
Flashing Communication control status
3 Operation Description of Inverter
Display
Description
contents
Parameters are being uploaded
Parameters are being downloaded
Normal
23