Operation Description Of Inverter; Name And Description Of Each Part Of Operation Panel; Appearance Of Operation Panel; Description Of Key Function - Dema Electric D6 Series User Manual

3.1 Name and description of each part of operation panel

3.1.1 Appearance of operation panel

3.1.2 Description of key function

Key appearance

3.1.3 Description of LED display function

There are 5 LED tubes that contain 8 parts on inverter operation panel, which can display and monitor data,
parameter number, parameters value, abnormal code and so on.
Inverter will flashing display abnormal code when abnormal (refer to Chapter 7.2) . Reset the abnormal by
input the abnormal resetting command (E.XXX type abnormal resetting command is ―ST O P/RESET‖,
resetting command of control terminal and serial communication terminal; AE.XXX type abnormal resetting
command is ―EN T ‖ or ―ES C ‖) , the abnormal code will display again after 5 seconds if the abnormal didn't
clear. During this time alter the parameters setting to exclude abnormal. In addition, operation panel can also
display such information showed as below by code type:
22

3 Operation Description of Inverter

Key name
ENTER Enter menu, enter parameters or affirm one parameter written.
ESC Return the status that before press ―ENT ‖
Function code, data and all model selection and increase or decrease
UP
modify.
In point start operation mode, increase means positive point running,
DOWN
decrease means reverse point running.
SHIFT State monitoring mode switch, the third menu parameters switch
DIR Turn Operation direction of inverter
RUN Run command
STOP/RESET Stop command/Fault reset command;
3 Operation Description of Inverter
Function description