Care & Clean Of Acrylic Parts - Tayana -48 Owner's Manual

condition. And check the lock nuts and pins.
（4） Check the condition of all underwater fittings
2.22 Care & Clean of Acrylic Parts
Acrylics are soft and their surface can be scratched easily by
improperly cleaning. The scrubbing tools for FRP surface should
never be used to clean these parts.
When installing or reinstalling acrylic parts that are fastened with
screws, do not use a power screwdriver to run the screws all the
way down. Make the last few turns by hand to avoid over
lightening and stress cracking the part.
To Clean Acrylic
（1） Use a mild soap and plenty of warm water with a soft, all
cotton cloth and apply only light pressure
（2） Rinse with clear water and dry by blotting with a damp
cloth
（3） Kerosene may be used to remove some grease or paint
！
WHEN CLEANING ACRYLIC PARTS, DO NOT USE
SOLVENT SUCH AS LACQUER THINNER, ACETONE
AND DO NOT USE ABRASIVE CLEANERS.
USE MILD DETERGENT WITH WARM WATER AND
PURE NATURAL COTTON CLOTH.
TO REMOVE FINE SCRATCHES YOU MAY USE
MEGUIARS
POLISHING COMPOUND.
AVOID HIGH TEMPERATURE WHEN POLISHING
MIRROR GLAZE
68
#17 BRAND OF