JUKI HZL-L series Instruction Manual page 31

6
⑬
7
8
⑥
①
②
①
②
6
7
⑭
8
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
After the buttonhole is finished, do not raise the foot or
buttonhole lever, simply start the machine again.
NOTE:
If the fabric is not feeding smoothly when sewing
a double layer buttonhole, increase the buttonhole
density.
Adjusting the Stitch Width and Density for
Buttonholes
Adjusting the stitch width
Press the cursor buttons
under the stitch width value "5.0" ① (default setting).
Press the
Press the
The stitch width can be varied from 2.5 to 7.0 depending
③
on the selected buttonhole.
Adjusting the stitch density
Press the cursor buttons
under the stitch density value "0.4" ① (default setting).
Press the
dense ② .
Press the
denser ③ .
The stitch density can be varied from 0.3 to 0.8 depending
on the selected buttonhole.
③
29
The buttonhole is sewn in the sequence as shown.
When the buttonhole is finished, the machine will stop
automatically with the needle in the up position.
Remove the fabric and place a pin just below the
bartack to prevent accidentally cutting the stitches.
Cut the opening with the seam ripper.
⑬ Pin
⑭ Seam ripper
When buttonhole sewing is finished, push the
buttonhole lever upward as far as it will go.
⑥ Buttonhole lever
button to increase buttonhole width ② .
button to decrease buttonhole width ③ .
button to make the buttonhole stitch less
button to make the buttonhole stitch
to move the cursor
to move the cursor