Important Do's And Don'ts; Gas Cylinder - Napoleon U405 User Manual

IMPORTANT DO'S AND DON'TS

DO'S
Read the entire instruction manual before operating the
gas grill.
Maintain proper clearance to combustibles (510mm (20")
to rear of unit, 155mm (6") to sides). Additional clearance
is recommended near vinyl siding or large panes of glass.
Leak test the unit before initial use, annually and whenever
any gas components are replaced.
Follow lighting instructions carefully when operating grill.
Burner controls must be off when turning supply cylinder
valve on.
Ensure sear plates are positioned properly according to
sear plate installation instructions.
Clean grease tray and sear plates regularly to avoid build-
up which may lead to grease fires.
Remove warming rack before lighting rear burner. (The
extreme heat will damage the warming rack.)
Use protective gloves when handling any hot components.
Use only gas cylinders which meet national and regional codes. Ensure that the cylinder can provide enough fuel to operate the appliance.
If in doubt, check with your local gas supplier.
• Always set the cylinder vertically on level ground next to the grill. (UK only)
• Use caution when handling the cylinder valve.
• Never connect a cylinder which does not meet local codes.
• Never store a spare cylinder in close proximity of an operating appliance. Cylinders must not be exposed to extreme heat or direct
sunlight.
CYLINDER INSTALLATION:
UK ONLY:
Place cylinder on level ground next to grill below right side shelf. Do not use bottom shelf to store tank.
IMPORTANT: Ensure that the hose is routed to maintain proper clearance to the underside of the unit.
CYLINDER CONNECTION:
Tighten regulator to cylinder valve.
a cylinder is hooked up, or if a part of the gas system is replaced.

GAS CYLINDER

Set cylinder into hole in bottom shelf.
Ensure that the gas regulator hose is kink free. Remove the cap or plug from the cylinder fuel valve.
DON'TS
Do not route hose behind front leg - hose must run around
front side of leg.
Do not use condiment tray to store lighters, matches or any
other combustibles.
Do not locate unit under unprotected combustible
construction.
Do not operate rear burner with main burners operating.
Do not leave grill unattended when operating.
Do not light burners with lid closed.
Do not move grill when hot or operating.
Do not allow cold water (rain, sprinkler, hose, etc.) to come
in contact with heated unit. A large temperature differential
can cause chipping in the porcelain.
Do not manipulate any parts that have been sealed by the
manufacturer.
Do not use the bottom shelf of the unit for spare cylinder
storage.
A leak test must be performed annually, and each time