Important Do's And Don'ts; Gas Cylinder - Napoleon PTSS215 User Manual

Hide thumbs Also See for PTSS215:
Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT DO'S AND DON'TS

Read the entire instruction manual before operating the gas grill.
Maintain proper clearance to combustibles (6" to rear of unit, 4" to
sides). Additional clearance is recommended near vinyl siding or
large panes of glass.
Leak test the unit before initial use, annually and and whenever
any gas components are replaced.
Follow lighting instructions carefully when operating grill.
Ensure sear plate is positioned properly. The holes must be
towards the right side of the gas grill.
Clean grease tray and sear plates regularly to avoid build-up
which may lead to grease fires.
Inspect the burner tube for spider webs and other obstructions
periodically. Clean the tube completely if you find any such
obstructions.

GAS CYLINDER

Use only gas cylinders which meet national and regional codes. Ensure that the cylinder can provide enough fuel to operate the
appliance. If in doubt, check with your local gas supplier.
• Always set the cylinder vertically on level ground next to the grill.
• Use caution when handling the cylinder valve.
• Never connect a cylinder which does not meet local codes.
• Never store a spare cylinder in close proximity of an operating appliance. Cylinders must not be exposed to extreme heat or direct
sunlight.
valve. Tighten regulator to cylinder valve.
and each time a cylinder is hooked up, or if a part of the gas system is replaced.
Ensure that the gas regulator hose is kink free. Remove the cap or plug from the cylinder fuel
Do not route hose underneath drip pan - proper hose clearance to
bottom of unit must be maintained.
Do not locate unit under unprotected combustible construction.
Do not leave grill unattended when operating.
Do not light burners with lid closed.
Do not move grill when hot or operating.
Do not use water, beer, or any other liquids to control flare-ups.
Do not pinch electrode lead between bottom surface of grill and
folding leg.
A leak test must be performed annually,

Advertisement

Table of Contents
loading

Table of Contents