Table of Contents
Advertisement
Access to projection effects
For access to the rotating aerial effects gobos, static gobo wheel and color filters:
1. Disconnect the fixture from power and
allow it to cool for 30 minutes.
2. Remove the head covers, position the
head at a convenient angle with the top
of the head facing upwards, and apply
the tilt lock (see "Access to the head" on
page 16).
3. See Figure 15. The projection module is
closest to the front of the fixture.
Release its two Torx 20 retaining screws
(arrowed).
4. See Figure 16. Note the position of the projection module multi-connectors (arrowed – their position is
marked on the PCB) and unplug the connectors. Release the module wireset from its cutout in the
chassis.
Figure 16: Releasing the projection module connectors
Service and maintenance
Figure 15: Removing the projection module
19
Advertisement
Table of Contents
