Martin MAC Viper AirFX Safety And Installation Manual page 11

Connecting to an AC mains power source
The MAC Viper AirFX power cable can be hard-wired to a building installation circuit or fitted with a cord cap
(mains plug) to allow connection to local AC mains power outlets. If you install a cord cap (mains plug),
install a grounding-type (earthed) plug, following the plug manufacturer's instructions. Table 1 shows some
possible mains power pin identification schemes; if the pins are not clearly identified, or if you have any
doubts about proper installation, consult a qualified electrician.
Wire Color
brown
blue
yellow/green
Applying power
See Figure 7. To apply power to
the MAC Viper AirFX, check that
the tilt lock is released, that the
base is held securely, and that
personal safety will not be put at
risk when the lamp strikes and the
fixture moves, then set the power
on/off switch B to I (On).
Check that the mains power on/off
switch B is set to O (Off) before
inserting or removing the power
input connector at the input
socket A, otherwise you may
cause arcing at connector
terminals that can damage them.
Shutting down power
For optimum lamp life, wait at
least 5 minutes after striking a
discharge lamp before dousing
the lamp.
It is also good practise to douse the lamp a few minutes before shutting down power. This gives the fans
time to cool the fixture down.
Pin Symbol
live L
neutral N
ground (earth)
Table 1: Cord cap connections
IN IN
Figure 7: Mains input socket and mains power on/off switch
AC power
Screw (US)
yellow or brass
silver
green
WARNING WARNING
Disconnect from Disconnect from
mains before mains before
servicing. servicing.
ATTENTION ATTENTION
Déconnecter du Déconnecter du
secteur avant secteur avant
entretien. entretien.
DMX DMX
OUT OUT
A B
:
:
11