Maintenance - Hyundai HYMT5080 User Manual

7

MAINTENANCE

Maintenance schedule.
System/
Component
Fuel leaks and spillages
Fuel tank, air and fuel
filter
Idle adjusting screw
Spark plug
Cylinder fin intake air
cooling vent
Exhaust, spark arrester
and cylinder exhaust
port
Throttle trigger STOP
switch
Cutting parts
Transmission
Screws/nut/bolts
Cutting attachment
guard
Oiling port
Guide bar
Sprocket
Saw chain
Make sure that the engine has been stopped and allowed to cool down
before carrying out any maintenance.
Contact with hot and/or moving parts may cause personal injury.
All maintenance operations - except those listed in the
operating instructions, must be performed by qualified service personnel
Procedure
Wipe out
Inspect/clean
See idle adjustment
Clean and adjust
Clean
Clean
Check operation
Replace as required
Grease
Tighten and /or replace
Make sure it is attached
Clean
Clean
Inspect and replace as
required
Inspect and sharpen.
Page 24
Every Every
Each use 25
hours hours
○
○ ○
○
○
○
○
○
○
○
○
○
○
Every
50 100 Note
hours
Replace as
required
Replace
carburetor
as required
Re-gap to
0.6 to 0.7
○
mm – or
replace
○
Not
○ adjusting
screws
○