Table of Contents
Advertisement
4. ASSEMBLY
4.1 Handle assembly.
4.1.1 Install the front handle as shown in the diagrams. Do not tighten the screws
until you have set the perfect working position with the carrying strap. The
front handle should be aligned with the engine.
1. Front handle
2. Screw 5 x 35
3. Nut 5
4.2
Connecting attachments and extension pole.
4.2.2
To connect the two parts of the drive shaft
together.
4.2.3
Depress the lever (1) up and move lower
handle (2) towards drive shaft.
4.2.4
Locate locking hole (4) and release lever (1).
4.2.5
Tighten locking knob (5) in a clockwise
direction.
4.3
Attaching cutter guard.
4.3.2
Using the three supplied screws offer the
guard to the underside of the trimmer
shaft and loosely insert the screws once all
there screws are located then firmly
tighten them up.
4.1
Mounting the brush cutter blade.
4.1.1.
Before mounting the brush cutter blade you will have to disassemble the
clamping flange fixings or disassemble the clamping flange fixings.
4.1.2.
You will need to lock the shaft using supplied tool (1) rotate shaft until it
locks.
4.1.3.
Use the supplied box spanner to remove the remove the nut (5) in a
clockwise direction then remove cover (4), clamping flange (3) and key piece
(2).
Qty 1
4. Cover
Qty 4
5. Front handle bar
Qty 1
6. Screw 4.2 x 9.5
Page 13
Qty 1
Qty 1
Qty 1
Hide quick links:
Advertisement
Table of Contents
