Hyundai HYMT5080 User Manual page 21

6.4.7. ALWAYS clear the area of cans, bottles, rocks, etc. Flying or whirling
objects may cause serious injury and damage to users or viewers. If an
object is accidentally flung out from machine, immediately stop and check
the machine.
6.4.8. Never let the machine run with damaged or defective parts.
6.4.9. In trimmer mode only use for trimming grasses.
6.4.10. Never raise the nylon cutting head above knee height during operation.
6.4.11. DO NOT use the machine on a slope or uneven ground or if there is the
chance of slipping or losing the stability
6.4.12. Never over cut instead cut short
lengths then lower until desired
height is achieved, as shown
below.
ALWAYSSTOP MACHINE before
removing grass deposits to
prevent overheating of the
drive axle. Grass deposits
occur when fibers of the
weed are involved around
the shaft under the shield.
This prevents the shaft from
cooling properly. Remove
grass deposits with a
screwdriver or similar tool
only when switched off the
machine.
6.5. Trimming round trees.
6.5.1. Trim around tree trunks slowly making sure that the nylon cord does not
come into contact with the tree trunk.
6.5.2. Walk around the tree from left to right, and approach the grass/weeds with
the tip of the thread.
6.6. To release more nylon cutting line.
6.6.1. To release new nylon line, run the machine at full throttle and tap the nylon
cutting head on the grass.
Page 21