Hyundai HYMT5080 User Manual page 8

1.8.1.14 Do not bend over far forward. Maintain proper footing and
balance Do not use the machine while standing on a ladder or on any
other unstable surface.
1.8.1.15 Children must not have access to the machine.
1.8.1.16 Spectators should be kept at a safe distance from the work
area, and at least 15 meters.
1.8.1.17 Keep hands and feet away from the nylon cutting head or metal
blade during operation.
1.8.1.18 Do not use the machine if you are tired, ill or under the
influence of medication, drugs or alcohol.
1.8.1.19 Only use an undamaged nylon cutting head. If you strike a rock or
other obstacle, stop the engine and check the cutting head. A
defective or un-balanced cutting head must never be used.
1.8.1.20 Before starting, after the failure or impact, make sure to check the
machine and make sure that it is in good condition.
1.8.1.21 Observe local regulations which may restrict the use of the machine.
1.8.1.22 Only use device with the cutting tool still in good condition.
1.8.1.23 Improper maintenance, or the use of non-compliant spare parts or
removal or modification of the safety devices can result in damage
to the unit and serious injury of so working person.
1.8.1.24 Secure unit during transport well to prevent loss of fuel, damage to
the unit and injury. Always install the protective part of the cutting
blade before transporting or storing the machine.
1.8.1.25 On machines with a clutch, you should check regularly that the
cutting accessory stops rotating when the engine is idling.
1.8.1.26 Check the machine before each use for loose fasteners, fuel leaks,
etc. Replace damaged parts damaged parts before use.
1.8.1.27 It is also necessary to have sufficient breaks and to change your
working position.
1.8.1.28 Do not store the machine in a closed area where fuel vapors as may
reach an open flame from hot water heaters, ovens, etc. Store the
machine only in a well-ventilated area.
1.8.1.29 IMPORTANT: When filling with fuel, make sure the engine is off
and cooled. Never refuel if the machine is running or is hot. If fuel is
spilled, wipe on this before you start the engine.
Page 8