Maintenance; Troubleshooting - Hyundai SF7A214 Manual

INSTRUCTION
the terms of the guarantee.

MAINTENANCE

WARNING! Before carrying out any maintenance operations, disconnect the
machine from the power supply.
WARNING! The line cutting blades (if supplied) may cause deep cuts.
- Regular cleaning and maintenance of your machine will ensure efficiency and prolong
the life of your machine.
- After each session, clear the spool, the spoolholder and the guard of grass and
mulch. If you are using the professional manual spool, loosen the knob all the way
and remove the spool to obtain access to the area that requires cleaning.
- Whilst trimming, keep the motor's ventilation vents clean and free of grass.
- Clean the machine with a soft brush or cloth.
- Do not spray or wet the appliance with water.
- Do not use detergents or solvents as these could ruin the machine. The plastic
parts can easily be damaged by chemical agents.
- If the line cutting blade breaks, have it replaced by contacting an authorised service
centre.

TROUBLESHOOTING

If the machine vibrates:
- disconnect the machine from the mains.
- disassemble the spool unit (if it can be replaced).
- clean the spool carrier carefully and remove any grass or other material left on this
unit. If vibration persists after reassembling, replace the spool unit with a new one.
If the machine does not start:
- check the electrical connections
- Check the extension cord or change the power socket.
- check the main switch in the house.
- check that the overload protection reset button, if any, is pressed.
If cut is poor and the machine performance decreases:
- adjust the cutting device length.
CAUTION! If after the above checks the machine does not work correctly or in
case of malfunctions different from those listed, have it checked by an authorised
service centre. Always refer to the machine model and serial number indicated
on the data plate or in the attached sheet.
STORAGE
- After each use, carry out a general cleaning of the entire machine and its ancillary
parts (see maintenance paragraph); this prevents mould from forming.
- Keep the machine out of the reach of children, in a safe, dry, temperate and dustfree
place.
- Store the trimmer away from direct sunlight, if possible in a dark or barely lit place.
- Do not store in a nylon bag as this could encourage the formation of damp
patches.
- At the end of the cutting season the machine should receive an overall cleaning and
thorough check-up of the condition of its components.
- Do not store the machine resting on the floor. Hang it by the upper handgrip so that
the guard does not touch anything. The resting of the guard on a surface could
alter its shape and therefore its dimensions and safety characteristics would be
ENGLISH
22
21