Hyundai HYMT5080 User Manual page 7

1.7.2 Noise emissions for this equipment is unavoidable. Carry out noisy work
at approved times and for certain periods. Limit the working time to
a minimum. For your personal protection and protection of people
working nearby it is advisable for them to wear hearing protection.
1.8 Additional safety guidelines.
1.8.1 This machine may only be used for trimming grass, weeds and
brushwood. Never use for other purposes, as this may result in
serious injury! Safety instructions must be observed. DO NOT
EXPOSE YOURSELF OR OTHERS TO THE RISKS. Follow these general
instructions:
1.8.1.1 Always wear safety goggles for eye protection. Long hair must
be tied back. Do not wear loose clothing or jewelry that could
get caught in moving parts of the machine. Safe, strong, non-
slip safety shoes should be worn. It is recommended that the
legs and feet are fully protected, to protect themselves during
the operation against flying objects.
1.8.1.2 Check the entire machine for loose/missing parts (nuts, bolts, screws,
etc.). Tighten/ replace before using the machine. Do not use accessories
with this machine other than those recommended/supplied by the
manufacturer. Otherwise serious injuries to the user or bystanders as
well as damage to the machine will result.
1.8.1.3 Keep the handles free of oil and fuel.
1.8.1.4 Always use the correct interface handles and shoulder strap.
1.8.1.5 Do not smoke when mixing fuel or when filling the tank.
1.8.1.6 Do not mix fuel in an enclosed area or near open fires.
Ensure sufficient ventilation / ventilation.
1.8.1.7 Mix and store the fuel mixture in a correctly marked
container, which is allowed by local regulations for such
use.
1.8.1.8 Never remove the fuel tank cap while the engine is running.
1.8.1.9 Do not operate the machine in enclosed spaces or buildings.
Exhaust gases contain harmful carbon monoxide.
1.8.1.10 Do not run and whilst using the machine. When making
machine adjustments turn it off and lace the machine always
on a flat clear surface.
1.8.1.11 Do not use the machine if it is damaged. Never remove
safety devices of the machine. Otherwise it may result in
serious injury to the operator or the spectator, and damage
to the machine will result.
1.8.1.12 Check the area to be cut, and remove any residue that may be
involved in the nylon cutting head or blade. Remove all possible
items that could fling around when the engine works.
1.8.1.13 Never leave the machine unattended.
Page 7