Maintenance - Hyundai HYBC3000 User Manual

4.2.5. Wear the harness as shown in the figure. The
blade turns anti-clockwise, therefore, be advised
operate the unit from right to left for efficient
cutting. Keep onlookers out of working area at least
15m (50 ft.).
In the event of an emergency press the
quick release button or pull the emergency
release flap.
4.3. Stopping the Machine
4.3.1. Decrease engine speed and run at an idle for a
few minutes, then turn off ignition switch.

5. MAINTENANCE

1 - The cutting attachment should under no circumstances rotate when the engine is
idling.
2 – Never start the engine without the complete clutch cover and tube assembled!
Otherwise the clutch can come loose and cause personal Injury.
5.1. Carburettor Adjustment.
adjustment the engine idle/racing speed should not
exceed that shown in the machine data table which is
3000 rpm
the factory, the carburetor is given a basic adjustment. A
further adjustment may be required, according to
climate and altitude, the carburetor has one adjuster.
5.1.1. Idle speed adjustment.
5.1.1.1.
attachment will not rotate. If adjustment is required, close the idle-screw (clockwise),
with the engine running, until the cutting attachment starts to rotate.
A cutting attachment can injure while it
continues to spin after the engine is
stopped or power control is released.
When the unit is turned off, make sure the
cutting attachment has stopped before the
setting the unit down.
Adjustment must be done by a qualified
person, and make sure that after
Fuel is mixed with air inside the
carburetor. When the engine is test run at
Check that the air filter is clean. When the idle speed is correct, the cutting
Page 12 Ver 4