Assembly Procedure - Hyundai HYBC3000 User Manual

3. ASSEMBLY PROCEDURE

3.1. Handle assembly.
3.1.1. Assemble the handles onto the upper shaft.
3.1.2. Tighten the handle knob.
3.2. Replacing the Cutting Blade.
3.2.1. Make sure the HT lead is removed from the
spark plug.
3.2.2. Make sure the brush cutter is switched off
and the engine is fully stopped.
3.2.3. Insert the 'prevent rotation' wrench or
equivalent into the back shield and the adaptor
semicircle hole to prevent the output shaft from
turning.
3.2.4. Loosen the nut with the socket wrench (T-
Wrench) by turning clockwise (view from top),
then remove spring washer, washer, cover cap,
spacer and cutter blade from the output shaft.
3.2.5. Remove the old cutter blade, and install the
new blade.
3.2.6. Install spacer B, the cover cap, the washer
and spring washer, then tight the nut.
3.2.7. Remove the 'prevent rotational wrench' or
equivalent from the back shield and adaptor.
3.2.8. Before use remove the transportation guard.
Anti-vibration systems do not guarantee that you will not sustain white finger
disease or carpal tunnel syndrome. Therefore, continual and regular users should
monitor closely the condition of their hands and fingers. If any of the above
symptoms appear, seek medical advice immediately.
Remove HT lead from spark plug when assembling the machine or changing parts.
Page 8 Ver 4