GE Monogram ZV750 Technical Service Manual page 8

Wall-mounted and island hoods
Hide thumbs Also See for Monogram ZV750:
Table of Contents

Advertisement

ELECTRONIC HOOD CONTROL DESCRIPTION
The electronic hood control system consists of the following parts: Entry/Display Assembly; Control PCB;
Triac; Fuse Holder; Motor Capacitor; Transformer; Halogen Lamps; Filter Microswitch; and Induc-
tion Fan Motor.
CAUTION: Components are electrically HOT on the electronic control when voltage is connected to the
hood even though the ON/OFF switch is in the OFF position.
1. ENTRY/DISPLAY ASSEMBLY
The replacement assembly WB27X10345 has 3 Printed Circuit Boards (PCB) mounted in a plastic enclo-
sure with 8 push buttons and a ribbon cable. The three PCBs are Fan Touch Control PCB, Lamp Touch
Control PCB, and Display PCB.
Note: Before replacing the assembly, check the operation of the other hood components by plugging the
new Entry/Display Assembly cable into connector CN5 on the Control PCB. If the unit does not work,
replace the control board first and then recheck whether the existing Entry/Display assembly is OK. The
harness in the hood can be used instead of the one supplied with the assembly by carefully removing the
five screws from the enclosure assembly and unplugging the cable.
Motor Capacitor
Black Box
Fuse Holder
Control PCB
Transformer
ZV750
2. CONTROL PCB
This PCB has an AC to DC power supply, microprocessor, and fan relays and is located in the black box in
the hood chimney area.
Note: The 5 green connectors are locking type. Use a small flat blade screwdriver to unlock as follows:
Insert screwdriver in the center of the space between the plug and connector receptacle on the PCB. Push
down on the screwdriver handle to pivot blade about 5 degrees and pull out the plug at the same time.
TO CHECK OPERATION OF CONTROL PCB:
Check that all 6 connectors are locked in place, no leads are broken, and connector solder joints are not
broken on PCB copper tracks.
Note: Mini Manual
on Control PCB
Cover.
3/16"
Terminal
1/4"
Black
Terminals
Orange
3/16"
Brown
Terminal
Triac
– 6 –
Entry
Control
Enclosure
GEA00015
Brown
1/4"
Terminals
Black
Orange
Triac
Motor
Capacitor
Control PCB
Note: Mini Manual
on Control PCB
Cover.
Black Box
Fuse Holder
ZV850
GEA00016

Advertisement

Table of Contents
loading

This manual is also suitable for:

Monogram zv850

Table of Contents