Entry/Display Assembly Replacement; Filter Microswitch Replacement1 - GE Monogram ZV750 Technical Service Manual

Entry/Display Assembly Replacement

Entry/Display Assembly
A
Fan Motor
Lamps (4)
ZV750
1. Remove 3 filters from hood.
2. Remove 2 screws (A) from hood and entry/display assembly.
3. Remove entry/display assembly from hood.
4. Remove the pusher bracket holding the display in place on
the face of the hood.
5. Remove the entire display.
Note: When reinstalling, ensure that all electrical connections are securely fastened, and the pusher
bracket and 2 screws are installed correctly. Check to be sure that the push buttons move freely through
the front surface of the control panel.
Filter Microswitch Replacement
Note: Model ZV750Y1 is shown; Model ZV750Y2 and later, and Model ZV850 have only one filter
microswitch.
1. Disconnect electrical power to hood assembly.
2. Remove 2 screws (A) and filter microswitch bracket (B) from fan.
3. Remove 2 screws (C) and microswitch box from bracket.
4. Remove microswitch (D) from microswitch box and cover.
5. Disconnect wires from microswitch.
6. Replace microswitch with new microswitch.
Note: When reinstalling, ensure that all electrical connections are securely fastened.
Filter Microswitch
Fan Motor
A
4 Lamps
Filter Microswitch
A
Transformer Entry/Display Assembly
A
Motor mtg.-4 Hex Screws
(Use 9/32" Socket With Extension)
ZV850
B
– 11 –
Filter
Microswitch
A
GEA00017
Entry
Control
Enclosure
C
D
GEA00029
GEA00015