Page 1
INSTALLATION INSTRUCTIONS AND OPERATION MANUAL...
Page 2
3. Contact your merchant for product replacement due to shipping damages, cosmetic damages or defects. 4. For all other issues, call 1-877-BUY-KOBE (289-5623), or e-mail to info@koberangehoods.com NO RETURN, NO REFUND, NO EXCHANGE IF: PRODUCT HAS BEEN INSTALLED...
Any repair carried out without the supervision of KOBE authorized agents will automatically void the warranty. KOBE will not be held responsible for any damages to personal property or real estate or any bodily injuries whether caused directly or indirectly by the range hood.
Page 5
What to Do In The Event Of a Range Top Grease Fire • SMOTHER FLAMES with a tight fitting lid, cookie sheet, or metal tray, and then turn off the burner. KEEP FLAMMABLE OR COMBUSTIBLE MATERIAL AWAY FROM FLAMES. If the flames do not go out immediately, EVACUATE THE AREA AND CALL THE FIRE DEPARTMENT or 911.
Duct Cover Box for RA0946DC (Included in CHX81 SQB-DC30-1 ONLY) {J} Duct Cover Extension Model No.: RA0946DC 3/16” x 3/8” (6 Pcs) Knob attached to baffle filter FOR MORE INFORMATION, PLEASE VISIT OUR W EBSITE www.koberangehoods.com CONTACT KOBE RANGE HOODS AT (626) 775-8880.
INSTALLATION PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING Calculation before installation To calculate the length of the installation, please refer to Table 1. (All calculation is measure in inches.) TABLE 1 A = Height of Floor to Ceiling B = Height of Floor to Counter Top (Standard: 36”) C = Preferred Height of Counter Top to Hood Bottom (Recommended...
Page 8
Figure 1 Preparation before Installation NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING. - Decide the location of venting pipe from the hood to the outside. Refer to Figure 1. - A straight, short venting run will allow the hood to perform more efficiently.
Page 9
Figure 4 Ductwork Installation Use 6” round steel pipe (not provided) to connect the plastic exhaust on the hood to the ductwork above. Use duct tape to make all joints secure and air tight. Refer to Figure 4. Wiring to Power Supply Figure 5 If hood is operating normally, connect three wires (black, white and green) to house wires...
Page 10
Duct Cover Installation (Cont.) Figure 7 NOTE: CAREFUL WHEN USING ELECTRICAL SCREWDRIVER, DAMAGE TO THE HOOD MAY OCCUR. Secure the outer duct cover to the hood mounting bracket with 4 (3/16” x 3/8”) screws (provided). Refer to Figure 7. Secure the inner duct cover with 2 (3/16” x 3/8) screws to the duct cover mounting Bracket.
OPERATING INSTRUCTIONS Model No.: CHX8130SQB-1 (30”) CHX8136SQB-1 (36”) CHX8130SQB-DC30-1 (30”) CHX8136SQB-DC30-1 (36”) CHX8136SQB-DC46-1 (30”) CHX8136SQB-DC46-1 (36”) Note: For best results, turn fan on prior to any preparation or cooking and keep fans running while cooking. Adjust speed as needed. To operate the fan function •...
MAINTENANCE SAFETY WARNING NEVER PUT YOUR HAND INTO AREA HOUSING THE FAN WHILE THE FAN IS OPERATING. To Clean Hood Surface CAUTION NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHS. DO NOT USE PAPER TOWEL ON STAINLESS STEEL. For optimal operation, clean range hood and all baffle/spacer/filter/oil tunnel/oil container regularly. *** Regular care will help preserve the appearance of the hood.
SPECIFICATIONS MODEL / SIZE For 30” model For 36” model CHX8130SQB-1 CHX8136SQB-1 CHX8130SQB-DC30-1 CHX8136SQB-DC30-1 CHX8130SQB-DC46-1 CHX8136SQB-DC46-1 COLOR 18-Gauge Commercial Grade Stainless Steel CONSUMPTION / AMPERE 180W / 1.5A NUMBER OF BLOWER DESIGN Seamless / Satin Finish BLOWER TYPE Single Horizontal Squirrel Cage EXHAUST Top: 6"...
MEASUREMENTS & DIAGRAMS All measurements in ( ) are millimeters. All inch measurements are converted from millimeters. Inch measurements are estimated. Front View Bottom View...
Page 15
MODEL NO.: CHX8130SQB-DC30-1 / CHX8136SQB-DC30-1 Extension Duct Cover RA0930DC * For the diagram of hood dimension, please refer to Page 11. MODEL NO.: CHX8130SQB-DC46-1 / CHX8136SQB-DC46-1 Extension Duct Cover RA0946DC * For the diagram of hood dimension, please refer to Page 11.
TROUBLE SHOOTING Issue Possible Cause Solution After Installation, The power is not on. Make sure the circuit breaker and the unit’s power is both motors and ON. Use a voltage meter to check the power supply. lights are not The wire connection is not secure. Check and tighten wire connection.
TWO-YEAR LIMITED WARRANTY FOR PARTS AND LABOR ON KOBE PREMIUM/ BRILLIA SERIES: For two years from the date of your original invoice from a KOBE authorized dealer, we will, at our sole discretion, choose to repair or replace the product free of charge that failed due to manufacturing defects.
Page 21
3. Have the model number 4. Have the serial number 5. Have a description of the nature of any defect in the product or part TO REQUEST WARRANTY SERVICE, PLEASE CONTACT THE KOBE RANGE HOODS SERVICE CENTER: KOBE Service Center (USA Only)
1. Date of purchase 2. Model No. 3. Serial No. For warranty service or spare parts purchase contact: KOBE Service Center (USA Only) Toll Free: 1-855-800-KOBE (5623) Email: kobe@adcoservice.com For service in Canada or to report a problem, please contact:...
Page 23
KOBE Range Hoods 11775 Clark Street Arcadia, CA 91006 USA www.koberangehoods.com This hood is made for use in the USA and CANADA only. We do not recommend using this hood overseas as the power supply may not be compatible and may violate the electrical code of that country.
Need help?
Do you have a question about the Brillia Series and is the answer not in the manual?
Questions and answers