Patch Work; Attaching Lace - JUKI HZL-353Z series Instruction Manual

3~7 4 , S
0
1~4
64

Patch work

Turn the stitch length dial to "4".
(HZL-353Z)
Turn the stitch length dial to "S".
(HZL-355Z, HZL-357Z)
These stitches are used to join
two pieces of fabric while
leaving a space between their
edges.
- Fold over the edges of the two
pieces of fabric for the hem
and baste the edges to a thin
piece of paper leaving a small
space between them.
- Stitch along the edge, pulling
both threads slightly when
beginning to sew.
* Use thicker than normal
threads for sewing.
- After sewing, remove the
basting and the paper. Finish
by tying knots on the reverse
side at the beginning and the
end of the seams.

Attaching lace

- Turn stitch length dial to the
desired length.
- Turn the stitch selector to
straight stitch, center needle
position.
- Fold in the edge of the fabric
(approximately 6 mm 1/4").
- Place the lace under the folded
edge of the fabric allowing it to
underlap the fabric slightly as
required by the pattern of the
lace.
- Sew on the edge of the fabric
fold.
- You can add a decorative
touch by using the satin stitch
to sew the lace.