TouchPad
Description
TouchPad
TouchPad cable
Before removing the TouchPad, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation,
turn the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the TouchPad:
1.
Disconnect the TouchPad cable from the system board (1).
2.
Remove the five Phillips PM2.0×2.0 screws (2) that secure the TouchPad to the computer.
3.
Remove the Mylar tape (3) from under the cable.
4.
Remove the TouchPad (4).
Reverse this procedure to install the TouchPad.
36
Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page
22).
21).
Spare part number
806516-001
841262-001