Self-Cleaning - Russell Hobbs RHI007 Instructions And Warranty

soleplate. Tip: Pull the garment with one hand to stretch it for more effective wrinkle
removal.
Note: It may be necessary to press the burst of steam button few times to start this
function. During the use of 'Burst of Steam', stop ironing when the SmartLight turns on and
then start ironing again only after the SmartLight has turned off.
Warning: Do not apply steam on any clothes or fabrics that are being worn by human or
pets. To prevent burns, do not direct the steam at people. The temperature of the steam is
very hot and will burn or scald.

SELF-CLEANING

This function removes the scale and minerals built up in the Steam Chamber and prevents
scale from clogging the steam vents. The iron will remain in the best condition if this
function is performed once every two weeks. You may choose to use the function more
frequently depending on the hardness of the water used or water available in your local
area.
1. Make sure that the appliance is unplugged from the mains supply outlet.
2. Set the steam slider to the "0"/ "no steam" / "OFF" position.
3. Fill the iron as described in "How to Fill the Water Tank" and fill the water tank up
to the MAX position. Do not put vinegar or other descaling agents in the water tank.
4. Place the iron on a stable surface in an upright standing position.
5. Connect the iron to mains supply outlet.
6. Allow the iron to heat up. The SmartLight will glow to indicate that the iron is
heating up.
7. The SmartLight will turn off when the required temperature is reached.
8. Disconnect the iron from mains power supply outlet.
9. Hold the iron horizontally over a sink.
10. Hold/ press the self-cleaning button in and gently shake the iron to and fro.
11. Steam and boiling hot water will emit from the holes on the soleplate which
contains impurities, scale, minerals and flakes (if any) that deposited in the Steam