Maintenance - Gardenline PCH25 User Manual

Maintenance

Maintenance
Note. Before cleaning your chainsaw or carrying out any maintenance procedure,
make sure that the engine is off and is cool. Disconnect the spark plug to prevent
accidental starting.
Maintenance to be preformed after each use
1. Loosen the filter cover knob (10) and remove the filter cover (9). (Fig AD&AE)
3. Split the air filter into
its two (Fig AF) and
clean the mesh. Dry
particles can be removed
by tapping on a hard
surface. More stubborn
dirt may require
washing out the filter
with petrol or using an air compressor.
4. Re-assemble the two halves and replace the air filter, filter cover (9) and knob (10).
(Fig AG)
5. Take off the guide bar (1) and maintain it as follows, remove any sawdust from the
groove in the guide bar. (Fig AH)
6. Make sure that the oil port is not clogged. Grease the nose sprocket at the tip of the
guide bar. (Fig AI)
7. Check for fuel and oil leakage and loose fastenings, especially those securing the
handles and the guide bar. If any defects are found, take the tool to an authorised
repair centre.
8. Clean any dust away from the cooling vents as clogged vents can cause overheating.
AFTER SALES SUPPORT
AD
AG
1800 909 909 www.powertoolsupport.com
A U S
AE
AH
23
email: help@globalpowerbrands.com
7
AF
AI
46460