Unpacking; Fitting The Bucking Spikes; Installing The Guide Bar And Chain - Gardenline PCH25 User Manual

Getting Started

Unpacking

Due to modern mass production techniques, it is unlikely that your chain saw is
faulty or that a part is missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has been rectified. Failure to
do so could result in serious personal injury.

Fitting the bucking spikes

Fit the bucking spikes as shown using
the two cross-headed screws provided. (Fig A)

Installing the guide bar and chain

WARNING.
Use work gloves for safety.
IMPORTANT.
when installing the guide bar and chain.
1. Pull the front guard (7) towards the rear of the saw until
there is a "click" to make sure that the chain brake is released. (Fig B)
2. Remove the chain cover by: -
a) Removing the chain drive cover nut. (Fig C)
b) Removing the rear side cover locking knob. (Fig D)
c) Removing the side cover. (Fig E)
3. Fully loosen the chain tensioning screw
(3) by turning in an anti-clockwise direction. (Fig F)
4. Place the guide bar (1) in position over the threaded stud
and locate on the two guide pins. Slide the guide bar fully
towards the sprocket of the saw. (Fig G)
D
AFTER SALES SUPPORT
The chain has sharp edges.
Front guard (chain brake) must be disengaged
E
1800 909 909
A U S
F
13
www.powertoolsupport.com
A
B
C
G
email: help@globalpowerbrands.com
4
46460