Fuel And Lubrication - Gardenline PCH25 User Manual

Fuel and Lubrication

• Do not use fuel mixtures that have been left standing for one month or more,
they can cause clogging of the carburettor.
Before storing the chainsaw for an extended period, empty the fuel tank, clean
it then run the motor to empty the carburettor.
Note. Do not discard an unwanted fuel container with household waste. It
must be taken to an authorised repository site.
Mixing fuel (25:1 mixing ratio)
Mixing ratio is 25:1
1 litre of petrol and 40 mls of 2-stroke oil OR
5 litres of petrol and 200 mls of 2-stroke oil
1. Measure out the quantities of petrol and oil to be mixed.
2. Put some of the petrol into a clean, approved fuel container.
3. Pour in all of the oil and mix well.
4. Pour in the rest of the petrol and again mix well (at least one minute).
5. It is very important to mix the two ingredients properly to prevent unnecessary
engine wear.
6. Make sure that the container is clearly labelled that it is 2-stroke mixture.
Fuelling the chainsaw
1. The engine must be stopped and cool. Place the chainsaw on its side with the
fuel tank cap facing upwards.
2. Make sure that the fuel mixture is well mixed.
3. Remove the fuel tank cap (22). (Fig P)
4. Fill the fuel tank to about 80%
of its capacity. (Fig Q)
5. Fasten the fuel cap securely and wipe up
any fuel spillage around the machine.
AFTER SALES SUPPORT
1800 909 909 www.powertoolsupport.com
A U S
P
16
email: help@globalpowerbrands.com
5
Q
46460