Adding Chain Oil; Starting The Chainsaw - Gardenline PCH25 User Manual

Operating Instructions

Adding chain oil

WARNING.
lubricated.
1. Place the chainsaw on its side with the oil cap facing up.
Unscrew and remove the oil tank cap (21). (Fig R)
2. Fill the tank to 80% capacity with chain oil. (Fig S)
3. Fasten the cap and wipe up any oil spillage.
4. Release the chain brake by pulling the front hand guard (7),
firmly towards the back of the chainsaw until a click is heard.
To check the chain brake has been released, you should be able
to move the chain by hand.

Starting the chainsaw

WARNING.
one hand. This is very dangerous as the chain may come in
contact with your body.
1. Fill the fuel and oil tanks respectively and tighten the caps
securely.
2. Set the On/Off switch (17) to On (the I position). (Fig T).
Make sure the brake is On when starting for safety, by pushing
the front guard forward.
3. When the machine is cold first pull out
the choke control (16) to the CHOKE
position. (Fully extended). (Fig U).
Note. Once the choke control has been pulled out,
it cannot be pushed back to the run position.
4. Depress the priming bulb (27) 6 times or when the bulb is full
of fuel. (Fig V).
Note. Points 3 and 4 are not required if engine is warm or
is being restarted. The choke returns automatically when the
trigger switch is operated.
AFTER SALES SUPPORT
Never start work unless the chain and bar are
Do not start the motor whilst the saw hangs from
1800 909 909
A U S
17
www.powertoolsupport.com
R
S
T
U
V
email: help@globalpowerbrands.com
6
46460