Operation; Guard Against Kickback - Gardenline PCH25 User Manual

Operating Instructions

Operation

WARNINGS.
• Always follow the safety instructions given at the front of this manual. This
chainsaw must only be used for cutting wood. It must not be used for cutting
other types of material. Do not use the chainsaw as a lever for lifting, moving or
splitting objects.
• Do not attach the chainsaw to a fixed stand.
• Do not attach any devices to the chainsaw other than those specified by the
manufacturer.
Helpful hints
• Do not force the saw into the cut. Apply only light pressure whilst running the
engine at full throttle.
• If the saw chain gets caught in the cut, do not try to remove it by twisting the
guide or pulling forcibly. Use a lever or wedge to open up the cut so that the saw
chain is freed.
While cutting, always:
• Run the chainsaw motor at full revs. This makes the job safer, as there is less
chance of pull-in or kick-back.
• Position your body to the left of the chainsaw so if it kicks back uncontrollably, it
goes over your right shoulder, never stand in the cutting line of the saw.
• Keep a firm grip with your left hand on the front handle, with your thumb
securely below the handle.
• The swivel of your wrist in a kick-back situation will activate the chain brake.
• Make sure the chain is tensioned correctly.

Guard against kickback

Check the operation of the chain brake each time you use the chainsaw.
Run the saw at full throttle for 1-2 seconds then push the front guard (7)
forwards. The chain should stop immediately. If the chain is slow to stop or only
slows down you must take the tool to an authorised repair centre to have the
brake band and clutch drum replaced. Disengage the chain brake by pulling the
AFTER SALES SUPPORT
1800 909 909 www.powertoolsupport.com
A U S
20
email: help@globalpowerbrands.com
6
46460