Panasonic KV-S5076H Service Manual page 117

*9 1 While pushing the "START/STOP Key" on the Control
7. Lamp Test
Panel, turn on the scanner.
2 Release the key after LED (Back) status changes to
blinking.
3 Push the "START/STOP Key" once to enter the test
selection mode.
4 Push the "START/STOP Key" once at the timing when
LED (Back) status is 7 (h)
5 Push the "START/STOP Key" once to turn on the CCD
Lamp (F).
6 Push the "START/STOP Key" once to turn off the CCD
Lamp (F) and to turn on the CCD Lamp (B).
7 Push the "START/STOP Key" once to turn on the CCD
Lamp (F) and CCD Lamp (B).
8 Push the "START/STOP Key" once to turn off the CCD
Lamp (F) and CCD Lamp (B).
9 Turn off the scanner to finish this test.
*8
Note:
For LED and indicators' position shown in the above figure, see Sec. 3.
*7
.
117
— — *9: Every time you
OFF  "START/STOP"
Key, the lamp
Blinking
status will change
Blinking 
periodically, as
Count
follows.
Lamp (F) ON
Lamp (B) OFF
Lamp (F) OFF
Lamp (B) ON
Lamp (F) ON
Lamp (B) ON
Lamp (F) OFF
Lamp (B) OFF
— —
Lamp (F) ON
Lamp (B) OFF
push the




