HP R100-Series Configuration And Administration Manual page 66

Note
The Parent MAC setting is not used in this example.
Configure R1 10 #3
1. Connect your computer to one of the router's LAN ports and access the web management
interface using the default IP address 192.168.1.1.
2. Set the System Mode.
Select System > Mode. For R1 10 #3, select the Bridge option and click Save. Wait for
the router to reboot in Bridge mode.
3. Set a static IP address for the router.
Select LAN > Settings. Set the IP address to 192.168.5.30.
Click Save, and then restart the web browser session using the IP address 192.168.5.30.
4. Select a common operating channel.
Select Wireless > Basic. Select the same radio band and channel as set for R1 10 #1.
5. Set a common SSID for each WDS link.
To configure SSIDs for R1 10 #3, select Wireless > Basic, enable the first two VAP
interfaces, and set the SSIDs as follows:
6. Enable WDS Mode for the VAP interfaces.
Select Wireless > WDS. For R1 10 #3 VAP interfaces, set the WDS Mode as follows:
Configure R1 10 #4
1. Connect your computer to one of the router's LAN ports and access the web management
interface using the default IP address 192.168.1.1.
2. Set the System Mode.
Select System > Mode. For R1 10 #4, select the Bridge option and click Save. Wait for
the router to reboot in Bridge mode.
3. Set a static IP address for the router.
Select LAN > Settings. Set the IP address to 192.168.5.40.
Click Save, and then restart the web browser session using the IP address 192.168.5.40.
4. Select a common operating channel.
Select Wireless > Basic. Select the same radio band and channel as set for R1 10 #1.
66 Wireless configuration
•
Set VAP 1 to HP31 (provides an access point service for wireless clients).
•
Set VAP 2 to HP22 (for WDS link with R1 10 #2).
•
Set VAP 1 to Disable.
•
Set VAP 2 to WDS-STA.