Table of Contents
Advertisement
Custom Door Panel Installation (Refrigerator or Freezer)
1
Remove handle side cabinet screws and trim
with a phillips screwdriver.
1/4"
off edges of
3
3/4 " panel
Install "Z" brackets onto back side of custom panels.
ote: If 1/4" back panel is used, the brackets will be
ote: A 1/4" back panel needs to be used to ensure proper
flush to the edge (back panel is 1/4" smaller than
3/4" panel dimension).
4
3 "
Align upper and lower "Z "brackets in door trim and
For the last 3" of installation, push evenly on the custom wood panel
push custom wood panel evenly toward the hinge until
near the side door trim in addition to pushing from the handle side.
approximately 3" from the hinge side door trim.
This ensures side "Z" bracket engagement with hinge side door trim.
46
2
Remove handle side door trim screws and panel
with a phillips screwdriver.
Door trim
Door
"Z" bracket
1/4" (0.5 cm) back panel
3/4 " (1.9 cm) custom panel
TOP VIEW
Proper "Z "brackets engagement.
insulation. If back panel is not used, the potential for
condensation is present.
5
6
Insert handle-side door trim making sure to engage
handle-side "Z" bracket in door trim. Install door trim screws.
Custom Freezer Door Panel Installation (Bottom Mount Only)
1
Open freezer door. Remove door trim screws and door
trim with a phillips screwdriver.
3
Align panel in door trim and push down evenly.
Ensure side and bottom "Z" bracket engagement with door trim.
7
Reinstall cabinet trim and screws.
1/4"
off edges of
2
3/4 " panel
Install "Z" brackets onto back side of custom panel.
ote: If 1/4" back panel is used, the brackets will be flush to the
edge (back panel is 1/4" smaller than 3/4" panel dimension).
4
Reinstall top door trim and door trim screws with a
phillips screwdriver.
47
Advertisement
Table of Contents
