Table of Contents
Advertisement
8
Mounting the reel stand
.01.04
Fig. 8 - 04
8
Commissioning the machine
.02
Check the machine, in particular the electrical cables and pneumatic connecting hoses
for any damage.
Clean the machine thoroughly and then oil machine and/or fill with oil (see chapter 12
Care and maintenance).
Have specialists ensure that the machine can be operated with the available electricity
supply and that it is connected correctly to the power supply (see chapter 3
Specifications). If not, the machine must not be operated.
Connect the machine to the compressed air system and adjust the compression (see
chapter 12.04 Checking and adjusting air compression).
8
Turning the machine on/off
.03
Turn the machine on/off (see chapter 7.01 On/off switch).
Check air compression and adjust if required (see chapter 12.04 Checking and
adjusting air compression).
Mounting and commissioning the machine
When the machine is commissioned, the zero point of the jig control must be
checked and adjusted, if required. (See chapter 8.04 Checking/setting zero
point).
Mount the reel stand according
to Fig. 8-04.
Then insert the reel stand in the frame
and secure with the enclosed nuts.
8 - 3
Advertisement
Table of Contents
