Connecting To An Analogue Stereo System - NAD S 570 Owner's Manual

Setup

CONNECTING TO AN ANALOGUE STEREO SYSTEM

Good quality sound of 2-Channel Stereo system can be achieved by connecting this DVD player to a receiver equipped with a two analogue audio
inputs (right and left) and speaker system (right and left front speakers).
From the MIXED AUDIO OUT
(L & R) Jacks
Audio cable
TO ENJOY GOOD QUALITY SOUND
You need to select from the OSD drop down menu, Audio, Analogue On, and 48K.
NOTES
• Switch the power off on the S570 before switching the SCART/S-VIDEO switch position.
• Refer to the owner's manual of your receiver as well.
• Before you connect the S570 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before
making any connections.
• Depending on your Digital sound decoder, the decode rate may be 96 or 48K.
• The output sound of the S570 has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level. Otherwise, the
speakers may be damaged by a sudden high volume sound.
• Turn off the receiver before you connect or disconnect the S570's power cord. If you leave the receiver power on, the speakers may be damaged.
22
From S-VIDEO / Component Video /
Composite or SCART
To the analogue input (L & R)
amplifier equipped with
analogue inputs.
S-VIDEO / Component / Composite
75–Ohm coaxial or SCART cable
To S-VIDEO / Component /
Composite or SCART
inputs of the TV.
TV or monitor with
audio/visual inputs
Audio system