Connecting To An Audio System - NAD T550DVD Owner's Manual

Connecting to an Audio System

You can listen to the sound of audio CDs and DVD video discs in stereo.
To S-VIDEO OUT
If the TV has an S-Video
Input, connect the DVD
player with the S-Video
cable (not supplied). It is
not necessary to connect
Video input jack (yellow)
jack.
Notes
Refer to the owner's manual of your audio system as well.
When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the
equipment from the wall outlet before making any connections.
If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case,
move the DVD play away from the tuner and radio.
The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver's volume to a
moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
Turn off the receiver before you connect or disconnect the DVD player's power cord. If you leave the receiver
power on, the speakers may be damaged.
Change the setting of speaker output in Initial Setup, from Multichannel to Two channel. (Refer to page 34)
Warning
Do not set the Audio Output of this DVD player to "Stream/PCM" unless you are connecting either the coaxial or
optical digital audio jack of this DVD player to an AV decoder that has the Dolby Digital (AC-3) decoding function.
Do not connect both the coaxial and optical sockets to the same decoder. High volume sound may damage your
hearing as well as the speakers.
To VIDEO
OUT
R
L
(white) (red)
or
To OPTICAL
OUT
To VIDEO INPUT
To SCART OUT or
COMPONENT OUT (YCbCr)
To S-VIDEO INPUT
CONNECTIONS
To AUDIO
OUT
To AUDIO
INPUT
(red)
(white)
To OPTICAL
INPUT
TV or monitor with
audio video Inputs
(yellow)
PAGE 15
Audio System