Preparing The Remote Control - NAD S 570 Owner's Manual

Insert the batteries into the remote control so you can use it to operate the S570.
1 Open the battery cover
2 Insert two batteries (AAA size)
3 Make sure to match the + and - on the batteries to the marks inside the battery compartment.
4 Close the cover
NOTES ON BATTERIES
Improper use of batteries may cause battery leakage and corrosion.
• To operate the remote control correctly, follow the instructions.
• Do not insert the batteries into the remote control in the wrong direction.
• Do not charge, heat, open or short-circuit the batteries.
• Do not throw the batteries into fire.
• Do not leave dead or exhausted batteries in the remote control.
• Do not use different types of batteries together, or mix old and new batteries.
• If you do not use the remote control for a long period of time, remove the batteries to avoid possible
damage from battery corrosion.
• If the remote control does not function correctly or if the operating range becomes reduced, replace
all batteries with new ones.
• If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new
batteries.
• The batteries should last about one year with normal use.
OPERATION OF THE S 570 WITH THE REMOTE CONTROL
This section shows you how to use the remote control. Point the remote control at the remote control
sensor and press the buttons.
NA D
SKIP
PROGRESSIVE
SCAN
HDCD
SCAN
30° 30°
23 ft (7m)
ON OFF
AUDIO SUBTITLE ANGLE
PROGRAM
CLEAR RANDOM
SEARCH ZOOM
MARKER
Distance: About 23 ft (7 m) from the front of the remote sensor
1 2 3
Angle: About 30 degrees in each direction of the front of the remote sensor
NOTES ON THE REMOTE CONTROL
• Do not expose the remote sensor of the S570 to a strong light source such as direct sunlight or
illumination. If you do so, you may not be able to operate the S570 with the remote control.
• Point the remote control at the remote sensor on the S570.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
Identification of Controls

PREPARING THE REMOTE CONTROL

7