Camera Tampering Detection Tab - Set The Camera Tampering Detection; Motion Detection Tab - Set The Motion Detection; Setting Items For Motion Detection - Sony SNC-EP520 User Manual

Camera tampering detection tab —
Set the camera tampering detection
Camera tampering detection
Select On to activate the function to detect the camera
tampering, such as direction shifting or spray. When you
select On, you can select the Sensitivity.
Sensitivity: Set the sensitivity of camera tampering
detection High, Middle or Low.
Detection status: Display the tampering detection state
of the time when Camera tampering detection tab is
opened. To clear the detection status, click Clear
button.
Note
Using the Privacy masking function reduces the
sensitivity of camera tampering detection. When camera
tampering detection does not work, set the sensitivity
higher. When a screen is masked more than 60%, the
camera tampering detection will refuse to respond even
if Sensitivity is set to High. Test this function before
using it.
OK/Cancel
See "Buttons common to every menu" on page 26.
Motion detection tab — Set the
motion detection
Motion detection detects moving objects in the camera
image and outputs an alarm.
Notes
• Before actual use, perform an operation test and
confirm that the motion detection function works
correctly.
• Using the Privacy masking function disables the
Motion detection function for the masked area.
• The Motion detection menu may not be displayed
depending on the function settings. To display the
Motion detection menu, configure as follows.
Installation tab in the System menu (page 32)
– Video out: Off (SNC-ZP550/ZR550)
Camera menu-Video codec tab (page 40)
– Letterbox: Off. (SNC-EP550/EP580/ER550/
ER580/ER585/ER585H/ZP550/ZR550)
– Cropping: Off. (SNC-EP550/EP580/ER550/
ER580/ER585/ER585H/ZP550/ZR550)
– Codec of Image 2: Off.
• The motion detection function deactivates during PTZ
control, and also while the camera is moving to a
preset position. Once PTZ control is completed or the
camera arrives at the preset position, the motion
detection function reactivates.
When the Motion detection menu is
displayed for the first time
When you click Motion detection, "Security Warning"
is displayed.
When you click Yes, ActiveX control is installed and the
Motion detection menu is displayed.
Notes
• If Automatic configuration is enabled in the Local
Area Network (LAN) settings of Internet Explorer, the
image may not be displayed. In that case, disable
Automatic configuration and set the Proxy server
manually. For the setting of the Proxy server, consult
your network administrator.
• When you install ActiveX control, you should be
logged in to the computer as Administrator.

Setting items for motion detection

Use the settings tab to set the conditions for the motion
detection function while observing camera images. This
menu is the same as the settings menu displayed when
you click Detection on Alarm transmission on the
e-Mail (SMTP) menu, or on the FTP client menu.
Click the desired item in the setting item list to set the
respective detection area.
Setting item list
Setting the Sensor input/Camera tampering detection/Motion detection — Event detection menu
Monitor screen
Setting area
83