Table of Contents
Advertisement
Interval
Specify the interval time used when condition is set to
and, then.
In the case the condition is set as 1 and 2, the system
sounds an alarm when either 1 or 2 happens, and the
other happens within the specified interval.
In the case the condition is set as 1 then 2, the system
sounds an alarm when 1 happens, and then 2 happens
within the specified interval.
If you select "or" condition, this setting will be ignored.
The maximum duration to be set is 7200 seconds.
Sensor input Tab — Set the sensor
input 1/2
Sensor input mode
Set the direction of the detected input signal to the
sensor input terminal of the camera.
Normally open: Triggers an alarm when the sensor
input is short-circuited.
Normally closed: Triggers an alarm when the sensor
input is open-circuited.
Notes
• Allow at least two seconds for the input signal to be
detected; otherwise, some events may not be detected.
• When you use video streaming via SSL connection,
reduce the number of video streaming that are
simultaneously transmitted, by setting the value of bit
rate or frame rate to a lower value.
Otherwise, some sensor input events may not be
detected.
Camera tampering detection Tab —
Set the camera tampering detection
46
Action input Menu — Setting the Sensor input/Camera tampering detection/Motion detection
Notes
• Adjust Focus/Zoom or images, before using camera
tampering detection.
If you perform them during camera tampering
detection, it may cause mis-detection.
• When the output mode is set to HDMI, 4K 25fps, or
4K 30fps, this function cannot be set.
Enable
Select the checkbox to activate the function to detect
camera tampering, such as direction shifting or spray.
Detection status
Display the tampering detection state of the time when
Camera tampering detection tab is opened. To clear the
detection status, click Clear button.
Motion detection Tab — Set the
motion/VMF detection
Motion detection responds to moving objects in the
camera image and triggers an alarm.
In VMF, an alarm sounds when motion is detected under
the motion detection setting, entering or passing through
a specified area or inspection line. An alarm also sounds
when an object has been left or removed from a specified
area or inspection line.
The detected object will be displayed on the monitor in
the green frame. The removed object and left object will
be displayed in the magenta frame.
When you click the Motion detection tab, the
authentication dialog appears. Enter the user name and
password.
The user name "admin" and password "admin" are set at
the factory for the Administrator.
Change the password from the factory setting for the
security of your devices.
Notes
• Set Image size 1 in the Video codec tab of the Video/
Audio menu to the maximum rate before setting the
motion detection.
• When the output mode is set to HDMI, 4K 25fps, or
4K 30fps, this function cannot be set.
What is VMF
VMF stands for Video Motion Filter.
VMF is a function for detecting an object entering or
passing through a specified area or inspection line, or
when an object has been left or removed from a specified
area or inspection line. Video/audio recording can be
performed synchronized with this alarm.
Hide quick links:
Advertisement
Table of Contents
