3. Verify that the above entry is added to the
Where,
•
The first parameter
•
The second parameter
command.
•
The third parameter
represented by the ^, are included between "DEC" and "TLZ9" elements.)
•
The fourth parameter
•
The fifth parameter
•
The sixth parameter
<VBAR> ST_LONG_ERASE <VBAR> ST_KNOWS_EOD)
•
The seventh parameter
•
The eighth parameter
•
The ninth parameter
(low _ hi) as defined below:
-- 0xfd is the vendor-unique density code for the 120-m DDS2 tape in the
uncompressed mode (4.0 GB).
-- 0xfe is the vendor-unique density code for the 120-m DDS2 tape in the compressed
mode (8.0 GB, assuming a 2:1 compression ratio).
•
The tenth parameter
For the TLZ09 tape drive, perform the same steps as for the TLZ9L, with the following
exceptions:
In step 2, instead of
"DEC 8GB 4mm Helical Scan", 12, "DEC^^^^^TLZ9",
Substitute:
"DEC 8GB 4mm Helical Scan", 13, "DEC^^^^^TLZ09",
For the TLZ10 tape drive, perform the same steps as for the TLZ9L, with the following
exceptions:
In step 2, instead of
"DEC 8GB 4mm Helical Scan", 12, "DEC^^^^^TLZ9",
DIGITAL TLZ09/TLZ10 Cassette Tape Drive and TLZ9L/TLZ1L Autoloader Owner's Manual C–5
Product Notes for Non-DIGITAL Platforms
st_conf.c
(DEC 8GB 4mm Helical Scan)
is the length of the vendor ID provided by the "inquiry"
(12)
is the vendor ID. (Ensure that five spaces,
(DEC^^^^^TLZ9)
is the drive type for the driver.
(ST_TYPE_DEFAULT)
is a block size in bytes.
(8192)
(ST_VARIABLE <VBAR> ST_BSF
is the maximum number of read retries.
(5000)
is the maximum number of write retries.
(5000)
(0xfd, 0xfd, 0xfe, 0xfe)
is the speed code (not used).
( 0, 0, 0, 0 )
file correctly.
is the name given to the drive.
<VBAR> ST_BSR
comprises the drive options.
comprises the density codes
for the TLZ09