1.
Open the fuel tank vent screw (in filler cap) on manual venting type fuel tanks.
2.
Connect the remote fuel line to the outboard. Make sure the connector is snapped into place.
3.
Position the fuel line primer bulb so the arrow on the side of the bulb is pointing up. Squeeze the
fuel line primer bulb several times until it feels firm.
4.
Set the lanyard stop switch to the "RUN" position. Refer to General Information - Lanyard Stop
Switch.
5.
Shift the outboard to the neutral ("N") position.
OPERATION
19748
28526
27348
19791
N
28522
40