Other Programming - Panasonic KX-TGD620 Series Operating Instructions Manual

Programming
3
MbN: Select "External" to monitor
from an outside line. a MEDITN a
MADDN
4
MbN: "Manual" a MOKN
5
Enter the desired name. a MOKN
6
Enter the desired number. a MOKN 2
times
R "Baby Monitor" will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to "On".
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "Off" a MOKN a MOFFN
Editing an outside monitoring number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "On" a MOKN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Edit" a MOKN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a
MOKN 2 times
Erasing an outside monitoring
number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "On" a MOKN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Erase" a MOKN
6
MbN: "Yes" a MOKN a MOFFN
32
KX-TGD62xE(en)_0319_ver023.pdf 32
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity Level" a MOKN
3
MbN: Select the desired setting. a MOKN
a MOFFN
Answering the baby monitor
n When monitoring with a handset:
Press M N to answer calls.
If you want to respond from the monitoring
handset, press MMUTEN.
R The monitoring handset will answer calls
automatically when the auto intercom
feature is set to "On" (page 19).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds. To
answer the call, press MOFFN, then press
M N.
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customise the name
of each handset ("Bob", "Kitchen", etc.). This is
2018/03/19 10:02:49