Baby Monitor - Panasonic KX-TG8563AZ Operating Instructions Manual

Programming
R We recommend selecting a different
ringer tone from the one used for
outside calls.
R To add other entries, repeat from step
3.
8
M N
Note:
R To stop the alarm, press
handset on the base unit or charger.
R When the handset is in use, the alarm will
not sound until the handset is in standby
mode.
Viewing entries
1
(middle soft key) a
2
To see the entries on the selected date,
press .
To see the schedule list, press
R You can see detailed information
about the schedule by pressing
Editing an entry
1
(middle soft key) a
2
a MbN: Select the desired entry.
3
a MbN: "Edit" a
4
Edit the date if necessary. a
5
Edit the time if necessary. a
6
Edit the text memo if necessary (30
characters max.; page 50). a
7
MbN: Select the desired alarm tone. a
2 times
8
M N
Erasing an entry
Schedule alarm entries are not erased
automatically after the schedule alarm sounds.
Erase unwanted entries.
1
(middle soft key) a
2
a MbN: Select the desired entry.
3
a MbN: "Erase" a
4
MbN: "Yes" a
34
5
Erasing all entries
1
2
3
or place the
4
5
6

Baby monitor

a
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
.
the house or place. The monitored handset
(placed in a baby's room, for example) will
.
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
a
R You should perform a test run of the baby
Note:
R Both the monitored and monitoring
R If the unit is connected to a PBX system,
R During the monitoring mode, battery
R The monitored handset never rings during
a
M N
(middle soft key) a
a
MbN: "Erase All" a
MbN: "Yes" a
MbN: "Yes" a
M N
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
handsets must select the same base unit in
order to use the baby monitor feature
(page 37).
you cannot set the baby monitor.
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
the monitoring mode. But if the monitored
handset is on the base unit, the base unit
ringer sounds. Turn off the base unit ringer
volume to not sound the ringer (page 27).
a